Installation of FRP or PC transparent roof
With the development of the times, the glass fiber reinforced plastic transparent tile is widely used in industrial plants, agricultural greenhouses and other places.There are still a lot of places that we need to pay attention to during installation and use. The following is a brief introduction for you to install and use the Glass fiber reinforced plastic transparent tile.
1、Glass fiber reinforced The plastic transparent tile needs a pilot hole before fixing, and the hole diameter must be larger than the diameter of the fixing screw 6-9mm.
Both the hole diameter must be greater than 50% of the diameter of the fixed tantalum wire for thermal expansion and contraction.Both the hole diameter must be greater than 50% of the diameter of the fixed tantalum wire for thermal expansion and contraction.Avoid internal stress cracking caused by thermal expansion and contraction.
2、Glass fiber reinforced plastic transparent tile is fixed with aluminum fasteners,the glass fiber reinforced plastic transparent tile is fixed by a glass fiber reinforced plastic transparent tile bracket and a self tapping screw,then glue seal glass fiber reinforced plastic transparent tile position is generally set in the cross.
3、Glass fiber reinforced plastic transparent tile and steel plate in the longitudinal overlap, the minimum must have 200mm overlap, and put two water stops.
4、Glass fiber reinforced plastic transparent tile is connected to the tapping screw and must have a waterproof cap.Glass fiber reinforced plastic transparent tile has a large amount of hot and cold deformation and is prone to friction sounds.Therefore, the glass fiber reinforced plastic transparent tile should have a large hole in the tapping nail. When installing the glass fiber reinforced plastic transparent tile, the flexibility of the glass fiber reinforced plastic transparent tile must be taken into account.
5、When glass fiber reinforced plastic transparent tile is fixed, a good flushing gasket must be used.Place it between the screw and the glass fiber reinforced plastic transparent tile for waterproof and dust proof. After inserting the waterproof gasket into the screw, lock it into the purline with an electric drill. This completes the fixing work of the glass fiber reinforced plastic transparent tile.