Installation of FRP or PC transparent roof

With the development of the times, the glass fiber reinforced plastic transparent tile is widely used in industrial plants, agricultural greenhouses and other places.There are still a lot of places that we need to pay attention to during installation and use. The following is a brief introduction for you to install and use the Glass fiber reinforced plastic transparent tile.

1.、Glass fiber reinforced The plastic transparent tile needs a pilot hole before fixing, and the hole diameter must be larger than the diameter of the fixing screw 6-9mm.

Both the hole diameter must be greater than 50% of the diameter of the fixed tantalum wire for thermal expansion and contraction.Both the hole diameter must be greater than 50% of the diameter of the fixed tantalum wire for thermal expansion and contraction.Avoid internal stress cracking caused by thermal expansion and contraction.

2、Glass fiber reinforced plastic transparent tile is fixed with aluminum fasteners,the glass fiber reinforced plastic transparent tile is fixed by a glass fiber reinforced plastic transparent tile bracket and a self tapping screw,then glue seal glass fiber reinforced plastic transparent tile position is generally set in a Cruz.

3、Glass fiber reinforced plastic transparent tile and steel plate in the longitudinal overlap, the minimum must have 200mm overlap, and put two water stops.

4、Glass fiber reinforced plastic transparent tile is connected to the tapping screw and must have a waterproof cap.Glass fiber reinforced plastic transparent tile has a large amount of hot and cold deformation and is prone to friction sounds.Therefore, the glass fiber reinforced plastic transparent tile should have a large hole in the tapping nail. When installing the glass fiber reinforced plastic transparent tile, the flexibility of the glass fiber reinforced plastic transparent tile must be taken into account.

5、 Quando a fibra de vidro reforçada telha transparente é fixa, uma boa junta de rubor deve ser usada.Place entre o parafuso e a fibra de vidro reforçada telha transparente de plástico para prova impermeável e de poeira.Depois de inserir a junta à prova d'água para o parafuso, trave-a na purina com uma broca elétrica.Isso conclui o trabalho de fixação da telha transparente de plástico reforçada de fibra de vidro.