Tai nghe

0086 757 81848277

bán hàng06rooftile

Hộp thư đầu

Quê hương > Tin tức > Công nghiệp Tin tức > How to install UPVC roof sheet.....
Liên hệ
Địa chỉ: Xiebian Ngành Công Nghiệp Park, Danzao Town, Nam Hải District, Thành Phố phật sơn, Tỉnh quảng đông, trung quốc
Thời gian làm việc: 8: 00-18: 00 (giờ Bắc Kinh)
Điện thoại doanh nghiệp: 86-757-81848277 +8613702632466
Fax: 86-757-81848277
Bây giờ liên hệ

Tin tức

How to install UPVC roof sheet?

  • Tác giả:Gabee
  • Phát hành vào ngày:2020-11-10

PVC roofing is a great way to top a garden shed, shop, or patio. It is an easy, low-cost work, and you can do it yourself. You only need some basic tools and materials. We will see two methods for installing the PVC roofing panels. The first method is to cut the panels to the desired length. Most panels come up to 16 feet, which means 4.9 m in length.


In fact, the length of sheets can be customized. you just need to measure the length and ask the factory cut sheets to right length, which is convenient. Allow for a minimum of 18 inches which means 46 cm if you need to lap to complete the run. Tin snips are slow but safe. Wear work gloves and find the longest pair you can. The next step you need to drill holes in them. Use a 316 inches which is 4.8 mm drill bit. Spacing for the holes on the ends and sides of the panels should be 6 to 8 inches which is 15 to 20 cm.

The next step is installing the panels. Place them directly onto purlins that are attached to the roof trusses, beginning on the outside edge. Close or cover the back end. These will stop the entry of rain, wind, and pests. Screw down the panels. Drilling the holes, and use 10 by 2 in which is 25.4 by 5.1 cm screws with polycarbonate washers. Continue across the roof until it is completely covered, lapping over the previous panel by at least 2.5 inches which is 6.4 cm minimum. Next, complete the opposite side. If your roof is 2-sided and not just a single slope, repeat the installation on the other side of the roof, and install a corrugated ridge cap as you proceed across with the panels.